How to Configure SNA Server for PU Passthrough (251313)

MORE INFORMATION

Configuring SNA Server for PU Passthrough Connections

1. On the SNA Server computer, configure two connections. The connection to the host can be any supported host connection type, including SDLC and channel adapters. The downstream connection must be an Ethernet or Token Ring connection. For this example, "connection A" will refer to the host connection and "connection B" will refer to the downstream connection.
2. Specify the MACADDR of the host as the Remote Network Address on connection A, and then specify the MACADDR of the downstream device as the Remote Network Address on connection B.
3. Select PU Passthrough as the remote end for both connections. The allowed direction and activation fields cannot be changed.
4. In the properties of one connection, select the other connection for Passthrough via Connection. This will notify SNA Server that data arriving on one connection should be passed to the other connection.
5. Before you configure the downstream SNA node, you may want to change the Remote End of connection A (connection to the host) to Host System, and then verify that the connection will activate successfully. Before you configure the downstream node, change the connection back to PU Passthrough.
6. On the downstream SNA device, the connection type is either Token Ring or Ethernet. The Remote Network Address for this connection should be the address of the SNA Server handling the PU Passthrough. You can obtain this address by typing ipconfig /all at a command prompt on the SNA Server computer. All LUs should be configured on the downstream node. This includes LU6.2 sessions, display, and printer sessions. Refer to the SNA Server online documentation for additional information about configuring display, printer, and LU6.2 sessions.

Note: If the host connection is to an AS/400 computer, you need to delete any existing controller descriptions for the SNA Server computer handling PU Passthrough. If the AS/400 Autocreate feature is enabled, a new controller description should be created on the AS/400 computer when the downstream device connects to the AS/400 computer for the first time. This new controller will have the name of the downstream device and the MACADDR of the SNA Server.

Troubleshooting hint: Because the SNA Server computer may have other host DLC connections defined, you may need to adjust the Service Access Point (SAP) addresses before this will work properly. This is required when two or more connections communicate with the same host destination. For additional information about SAPs, click the article number below to view the article in the Microsoft Knowledge Base: