Setver.exe Is Not Loadable in Windows Millennium Edition (250238)


The information in this article applies to:

  • Microsoft Windows Millennium Edition
This article was previously published under Q250238

SYMPTOMS

If you run Setver.exe at a command prompt in Windows Millennium Edition (Me), you receive the following error message:
NOTE: Setver device not loaded. To activate Setver version reporting you must load the Setver.exe device in your Config.sys.

CAUSE

"Device=" entries in the Config.sys file are not processed by Windows Me. Previously installed real-mode programs are not loaded at startup with Windows Me.

STATUS

This behavior is by design.

MORE INFORMATION

This information also affects real-mode device drivers. For assistance to obtain Windows Me-compatible device drivers for a device, contact the device manufacturer.
Modification Type:MinorLast Reviewed:9/28/2004
Keywords:kberrmsg kbprb KB250238
©2004 Microsoft Corporation. All rights reserved.