Stop 0x00000050 Error Message Appears on Terminal Server with Lexmark Printer Driver (249917)


The information in this article applies to:

  • Microsoft Windows NT Server 4.0 Terminal Server Edition
This article was previously published under Q249917

SYMPTOMS

When you try to print from a Terminal Server client computer to a Lexmark printer, you may receive a STOP 0x50 error message.

RESOLUTION

To work around this behavior, perform the following procedures:

  1. Obtain the generic Lmpcin41.dll printer driver from Lexmark.
  2. On both the Terminal Server computer and the print server, replace the existing Lexmark printer driver with the Lmpcin41.dll printer driver.
  3. On each Terminal Server client, delete the Lexmark printer and then create a new printer that points to the new printer driver.

MORE INFORMATION

Using the generic Lmpcin41.dll printer driver resolves the STOP error message, but it also disables some of the features of your printer.

For information about how to contact Lexmark International, Inc., click the appropriate article number in the following list to view the article in the Microsoft Knowledge Base:

65416 Hardware and Software Third-Party Vendor Contact List, A-K

60781 Hardware and Software Third-Party Vendor Contact List, L-P

60782 Hardware and Software Third-Party Vendor Contact List, Q-Z


The third-party products that are discussed in this article are manufactured by companies that are independent of Microsoft. Microsoft makes no warranty, implied or otherwise, regarding the performance or reliability of these products.
Modification Type:MajorLast Reviewed:6/30/2004
Keywords:kbprb KB249917
©2004 Microsoft Corporation. All rights reserved.