ACC2000: Startup Properties in an ADP Are Not Preserved When You Restore a Project from Visual SourceSafe (248977)


The information in this article applies to:

  • Microsoft Access 2000
  • Microsoft Office 2000 Developer
This article was previously published under Q248977
Moderate: Requires basic macro, coding, and interoperability skills.

This article applies only to a Microsoft Access project (.adp).

SYMPTOMS

When you are working with a Microsoft Access project (ADP) and Microsoft Visual Source Safe (VSS), and you click Get Latest Version command or the Create Database from SourceSafe Project command, some of the startup properties of the database are reset to their default values. Whatever values were stored for those properties in the VSS project are lost.

This article assumes that you are familiar wit using the capabilities of Visual SourceSafe. For more information about Visual SourceSafe, please refer to the "Visual SourceSafe User's Guide" or Visual SourceSafe Help.

RESOLUTION

To resolve this problem, obtain Microsoft Office 2000 Service Release 1/1a (SR-1/SR-1a).

To obtain SR-1/SR-1a, click the article number below to view the article in the Microsoft Knowledge Base:

245025 OFF2000: How to Obtain and Install Microsoft Office 2000 Service Release 1/1a (SR-1/SR-1a)

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article. This problem was corrected in Microsoft Office 2000 SR-1/SR-1a.

MORE INFORMATION

Steps to Reproduce Behavior

  1. Create a new Access project, and name it Prop.adp.
  2. On the Tools menu, click Startup.
  3. In the StartUp dialog box, set the following options:

    Display Status Bar: False
    Allow Toolbar/Menu Changes: False

  4. On the Tools menu, point to SourceSafe, and then click Add Database to SourceSafe.
  5. Click Yes to close the database in order to add it to Visual SourceSafe. Log on to Visual SourceSafe, add the Prop project, and then click Yes to create it.
  6. Create a new Access project, and name it LostProp.adp.
  7. On the Tools menu in Access, point to SourceSafe, and then click Create Database from SourceSafe Project. Log on to Visual SourceSafe when you are prompted, select the Prop project, and then click OK.
  8. When Visual SourceSafe informs you that it has completed the operation successfully, click OK, and then click Close.
  9. On the Tools menu, click Startup.
    Note that the Display Status Bar property and the Allow Toolbar/Menu Changes property are now set to True.
Modification Type:MajorLast Reviewed:11/25/2002
Keywords:kbbug KB248977 kbAudDeveloper
©2002 Microsoft Corporation. All rights reserved.