Component Builder Appears to Change Component's Transaction ID, But Does Not Change It (233550)


The information in this article applies to:

  • Microsoft COM Transaction Integrator for CICS and IMS 4.0 SP2
This article was previously published under Q233550

SYMPTOMS

When you design COM Transaction Integrator for CICS and IMS (COMTI) components using Component Builder (CB), it may seem possible to change the "Transaction ID" of a locked method. However, when you save the component, the presumed change does not persist.

In some cases, when a method is locked, the edit box for the Transaction ID in the Host Names properties is not disabled. At the same time, the title for the edit box, Transaction ID, is grayed out. Component Builder allows changing the Transaction ID value in the edit box. Then, if the dialog box is closed and reopened, the Transaction ID is restored to its original value.

If you do not make that check, you might save the component library and test with it. The testing would be confounded because the Transaction ID would not be set to the new value.

One place in particular that this could cause a problem is after you have used the Import COBOL Wizard of Component Builder to create a new method in a component library. After this process, the method is in the "Locked" state. Nevertheless, the Transaction ID edit box is enabled, and you can change the value of the Transaction ID. However, as above, the change is not persistent.

WORKAROUND

If the component is installed in an Microsoft Transaction Server (MTS) package, delete it by taking these steps:
  1. Right-click My Computer in MTS Explorer, and click Shut Down Server Processes.
  2. Select the Components folder of the appropriate MTS package, right-click the component, and click Delete.
Then change the Transaction ID:
  1. Start the Component Builder, and open the component library.
  2. Right-click the method name, and click Unlock.
  3. Right-click the method name, and click Properties.
  4. Click the Host Names tab.
  5. Change the Transaction ID to the appropriate value.
  6. Close the dialog box, and lock the method again.
  7. Save the component library.
  8. Reinstall the component library in its MTS package.

STATUS

Microsoft has confirmed that this is a problem in Microsoft SNA Server version 4.0.
Modification Type:MinorLast Reviewed:3/25/2004
Keywords:kbbug kbpending KB233550
©2004 Microsoft Corporation. All rights reserved.