Enable Point to Point IP and IP Packet Size Options Missing (233177)


The information in this article applies to:

  • Microsoft Windows 95
This article was previously published under Q233177

SYMPTOMS

After you upgrade to Dial-Up Networking version 1.3, the "IP Packet Size" and "Enable point to point IP" options are missing in Dial-Up Adapter properties.

RESOLUTION

To resolve this issue, use either of the following methods:

Uninstall and Reinstall Dial-Up Networking Version 1.3

You can uninstall and then reinstall Dial-Up Networking version 1.3.

Remove Instances of Dial-Up Adapters and VPN Adapters

If Dial-Up Adapters were already installed when you installed Dial-Up Networking version 1.3, you can remove all instances of "Dial-Up Adapter" and "Microsoft Virtual Private Networking Adapter" listed in the Network tool in Control Panel to resolve this issue. Note that after removing these adapters, you must add two "Dial-Up Adapter" entries, and one "Microsoft Virtual Private Networking Adapter".

MORE INFORMATION

For related information, please see the following articles in the Microsoft Knowledge Base:

154091 Windows 95 Dial-Up Networking 1.3 Upgrade Release Notes

191494 Dial-Up Networking 1.3 Upgrade Available

Modification Type:MajorLast Reviewed:12/17/2000
Keywords:kbnetwork kbprb kbui KB233177
©2002 Microsoft Corporation. All rights reserved.