MapPoint 2000: Unable to Link or Import More than 1000 Records (231529)


The information in this article applies to:

  • Microsoft MapPoint 2000
This article was previously published under Q231529

SYMPTOMS

When you attempt to link or import data from a Microsoft Excel workbook to Microsoft MapPoint 2000, you may receive the following error message:
Only 1000 records may be placed at one time using Street Address.
When you click OK, the remaining records in the workbook are not mapped.

CAUSE

This behavior can occur if both of the following conditions are true:
  • The Excel workbook from which you link or import data contains more than 1000 records.

  • The records you link or import include street addresses.

RESOLUTION

To work around this issue, use either of the following methods:
  • Make sure the workbook from which you link or import data contains a maximum of 1000 records.

  • Do not include street addresses in the records you link or import.

STATUS

This behavior is by design.

MORE INFORMATION

You can map all records in a workbook that contains over 1000 records by using geographic information that is less specific than street addresses, such as ZIP codes.
Modification Type:MajorLast Reviewed:9/14/2001
Keywords:kberrmsg kbinterop kbprb KB231529
©2002 Microsoft Corporation. All rights reserved.