FIX: Visual InterDev Error When Switching to Source View with DTCs (224936)


The information in this article applies to:

  • Microsoft Visual InterDev 6.0
This article was previously published under Q224936

SYMPTOMS

Visual InterDev 6.0 fails with a General Protection Fault (GPF), when switching from Design View to Source View if a Page Transition (Design-Time Controls) DTC and Recordset DTC have been added to an Active Server Pages (ASP) page.

STATUS

Microsoft has confirmed that this is a bug in the Microsoft products that are listed at the beginning of this article.

This bug was corrected in Visual Studio 6.0 Service Pack 3. For more information about Visual Studio service packs, please see the following articles in the Microsoft Knowledge Base:

194022 INFO: Visual Studio 6.0 Service Packs, What, Where, Why

194295 HOWTO: Tell That Visual Studio 6.0 Service Packs Are Installed

MORE INFORMATION

Steps to Reproduce Behavior

  1. Open an ASP page.
  2. Add a Page Transition DTC within the <head></head> tags.
  3. Switch to Design View.
  4. Add a Recordset DTC to the page.
  5. Answer Yes to the enable SOM prompt.
  6. Switch back to Source View.

Result: Visual InterDev will cause a General Protection Fault and shut down.
Modification Type:MajorLast Reviewed:10/15/2002
Keywords:kbBug kbCtrl kbDSupport kbide kbVS600SP1fix kbVS600sp2fix kbVS600sp3fix KB224936
©2002 Microsoft Corporation. All rights reserved.