PPT2000: Sample Visual Basic Code That Detects When a Slide Show Ends (222700)

MORE INFORMATION

Microsoft provides programming examples for illustration only, without warranty either expressed or implied. This includes, but is not limited to, the implied warranties of merchantability or fitness for a particular purpose. This article assumes that you are familiar with the programming language that is being demonstrated and with the tools that are used to create and to debug procedures. Microsoft support engineers can help explain the functionality of a particular procedure, but they will not modify these examples to provide added functionality or construct procedures to meet your specific requirements. NOTE: The following macro examples work only in PowerPoint. Visual Basic for Applications macros are not supported by the Microsoft PowerPoint Viewer. For additional information, click the following article number to view the article in the Microsoft Knowledge Base:

Sample Visual Basic Procedure

   Sub SlideShowStatus()

      ' Enable error trapping.
      On Error Resume Next
      Err.Clear

      Dim ppt As Object

      ' Get an object reference to PowerPoint. This code
      ' assumes PowerPoint is running. If PowerPoint is not
      ' running, the Err object gets set.
      Set ppt = GetObject(, "PowerPoint.Application.9")

      ' Check if an error occurred when running GetObject.
      If Err.Number <> 0 Then
         MsgBox "PowerPoint is not running. Start PowerPoint, open a " _
            & "presentation, and run the code again."
         End
      End If

      ' Starts a slide show. This code assumes a presentation
      ' is open. If a presentation is not running the Err object
      ' is set.
      ppt.ActivePresentation.SlideShowSettings.Run

      ' Make sure the pointer is visible.
      ' SlideShowWindows(Index:=1).View.PointerType= ppSlideShowPointerArrow

      ' Check if an error occurred when running GetObject.
      If Err.Number <> 0 Then
         MsgBox "A presentation is not open. Open a presentation and " _
            & "run the code again."
         End
      End If

      ' This loop checks to see if the slide show has ended. When the
      ' code sets the Err object, the slide show is ended.
      Do
         DoEvents
      Loop Until ppt.SlideShowWindows(1).View.State = ppSlideShowDone

      ' Check if the slide show has ended.
      If Err.Number = 0 Then

         ' The slide show did not end. The code should never
         ' flow here.
         MsgBox "Slide Show did not end!"
         End

      Else

        ' The slide show has ended.
        '
        ' NOTE: If you are running this code from a control on a form,
        ' you should give focus back to your form (Form1.GetFocus) here.
        MsgBox "SLIDE SHOW DONE!"

      End If

   End Sub