Use of the [SetupParams] Section in an Unattended Answer File (216518)

SUMMARY

You can use a command-line switch with Winnt32.exe or Winnt.exe to specify a command to run when Setup is finished. The command-line switches are:

Winnt.exe: /E:command
Winnt32.exe: /cmd:command

When you use one of these switches, you can specify a command to run when Setup finishes, but before the system settings are saved. You can type these commands directly to start Setup, or you can place the command in an unattended Setup answer file.

MORE INFORMATION

To use one of the switches listed above in an unattended Setup answer file, add a [SetupParams] section to your answer file. The [SetupParams] section should have the following syntax:

[SetupParams]
UserExecute = path to command or executable

The following restrictions apply:

You can enter only one command. If more than one "UserExecute" line exists, the first line is run and the rest are ignored.
If the command or executable is not located in the %SystemRoot% folder or search path, the full path must be specified.