WD2000: Frame Does Not Copy from One Column to Another (212108)


The information in this article applies to:

  • Microsoft Word 2000
This article was previously published under Q212108

SYMPTOMS

When you try to copy and paste a frame from one column to another column using newspaper-style columns, the following behavior occurs:
  • The frame is not pasted into the destination column. -and-

  • A duplicate copy of the frame appears in the original column.

CAUSE

This functionality is by design. Frames retain their Relative to setting when copied. If the Relative to setting of the original frame is set to Page, the pasted frame has this setting also. (To see the Relative to settings, go to the Frame dialog box. For more information, see the "More Information" section of this article.)

WORKAROUND

To work around this problem, use either of the following methods:
  • Drag the duplicate frame to the correct location.

    -or-
  • Select the frame and modify its properties.

MORE INFORMATION

To insert a frame into a Word document, follow these steps:

In Word 2000, the Frame command is not on the Insert menu. You can use a text box instead. However, if you want to use a frame, follow these steps:
  1. On the Tools menu, point to Macro and click Macros.
  2. In the "Macros in" box, click to select Word commands.
  3. In the macro list, click to select InsertFrame, and then click Run.

    NOTE: When you first run this command, Word prompts you with the following message:
    You inserted a frame but Insert Frame is not on any menu. Press the button below to add Frame to the Insert menu so you can quickly and easily insert frames.
    Click Yes if you want Word to add Frame to the Insert menu.

    Click Cancel if you do not want Word to add Frame to the Insert menu.
If you want to add another frame, you need to repeat steps 1-3 again.
Modification Type:MajorLast Reviewed:12/6/2000
Keywords:kbframe kbprb KB212108
©2002 Microsoft Corporation. All rights reserved.