XL2000: Cannot Use Object Box When Multiple Controls Are Selected (211684)
The information in this article applies to:
This article was previously published under Q211684 SYMPTOMS
When you click the Object box in the Properties window (click the Properties tool on the Control Toolbox toolbar) in Microsoft Excel 2000, no controls or objects are listed.
CAUSE
This problem occurs when both of the following conditions are true:
- You insert two or more controls on a worksheet or UserForm.
- You select two or more of the controls.
WORKAROUND
To work around this behavior, select a single control in the Object box. To do this, first clear all selected controls by clicking anywhere in the worksheet or in the UserForm. After you clear the controls, you can use
the Object box to select a single control.
MORE INFORMATION
In Microsoft Excel 2000, you can use either of the following methods to
display the Properties window.
Method 1: Worksheet or Chart Sheet Is Active
On the View menu, point to Toolbars, and click Control Toolbox. Then, click the Properties tool in the Control Toolbox.
Method 2: The Visual Basic Editor Is Active
On the View menu, click Properties Window. Or, press F4.
The Object box is the list box at the top of the Properties window.
Normally, you can use the Object box to select a single control in a
worksheet or UserForm. However, if you select two or more controls by
holding down CTRL or SHIFT, and then clicking the controls, you cannot use
the Object box to select or switch to a single control. When you click the Object box, a thin black line appears below the Object box but no controls are listed.
NOTE: If you make any changes to the Properties window when multiple controls are selected, the changes are applied to all of the selected controls.
| Modification Type: | Major | Last Reviewed: | 9/27/2003 |
|---|
| Keywords: | kbprb kbProgramming KB211684 |
|---|
|