WD2000: Pleading Wizard Uses Negative Margins (211611)


The information in this article applies to:

  • Microsoft Word 2000
This article was previously published under Q211611

SYMPTOMS

The top and bottom margins of a document created by the Pleading Wizard are a negative measurement. For example, the top and bottom margins are set to -1".

NOTE: To view the margin settings of the completed pleading document, click Page Setup on the File menu. Then click to select the Margins tab.

CAUSE

The top and bottom margins are set to a negative measurement to prevent changes in the header and footer from causing alignment problems with the body text and the line numbers. The negative measurement prevents the header or footer area from growing.

MORE INFORMATION

Word normally sets a positive measurement for the header or footer area. If the footer content expands outside of the footer area--the distance between the edge of the page and the measurement defined for the footer--then as the bottom margin increases, the body text area decreases. This would negatively affect line numbering.

When you use a standard bottom margin and the footer content exceeds the margin size, the bottom margin increases in size, allowing for a smaller text area. This smaller text area may cause problems with the line numbers in the body of the document. For example, if the bottom margin is increased, the body area decreases, thus allowing for fewer line numbers.

If you have margins that are set to negative values, Word defines the footer to be a certain size. If the footer contents exceed the bottom margin size, they are clipped and Word does not change the size of the body area. As a result, the line numbers are not disturbed.

In most pleading documents, the footer size is not as important as the line numbers. If the footer content is truncated, you modify the footer content rather than trying to adjust the line numbers (modifying the footer content is easier than adjusting the line numbers).

For additional information, click the article number below to view the article in the Microsoft Knowledge Base:

211311 WD2000: Pleading Wizard Font Point Size Is Too Small or Too Large

Modification Type:MajorLast Reviewed:12/6/2000
Keywords:kblayout kbprb kbtemplate KB211611
©2002 Microsoft Corporation. All rights reserved.