Windows NT 4.0 Does Not Recognize Jaz Drive During Setup (206134)
The information in this article applies to:
- Microsoft Windows NT Workstation 4.0, when used with:
This article was previously published under Q206134 SYMPTOMS
When you install Microsoft Windows NT Workstation 4.0 on a small computer system interface (SCSI) system with an Iomega Jaz drive that can be used as a bootable device, Windows NT Setup does not recognize the drive as a fixed disk. Installation to the Jaz drive will not succeed.
RESOLUTION
To resolve this behavior, set the computer's BIOS boot sequence so that SCSI is recognized first.
Modification Type: | Major | Last Reviewed: | 11/5/2003 |
---|
Keywords: | kbHardware kbprb kbsetup KB206134 |
---|
|