TC1000: Cannot Learn Infrared Codes from Working Remote Control (196825)


The information in this article applies to:

  • Take Control Editor 1.0
This article was previously published under Q196825

SYMPTOMS

When you use the learning feature of the Take Control System Controller (TC1000), the TC1000 may not be able to learn the infrared codes from a working remote control or the learned codes may not function properly.

CAUSE

This behavior can occur if the working remote control uses an infrared frequency higher than 120 kilohertz (kHz).

MORE INFORMATION

Manufacturers of remote control devices that use infrared frequencies higher than 120 kHz include:

Remote Control ModelFrequency
Kenwood Receiver-KR-V990D455 kHz
Kenwood Receiver-KR-V9080 455 kHz
Sony Receiver-STR-DA90ESG455 kHz
Sony Receiver-STR-DE805G455 kHz
Pioneer TV-SD-P5795W1 MHz
Pioneer TV- SD-P60851 MHz


The third-party products that are discussed in this article are manufactured by companies that are independent of Microsoft. Microsoft makes no warranty, implied or otherwise, regarding the performance or reliability of these products.
Modification Type:MajorLast Reviewed:7/27/2001
Keywords:kb3rdparty kbHardware kbprb KB196825
©2002 Microsoft Corporation. All rights reserved.