Unable to Rename Items on Controller (196101)


The information in this article applies to:

  • Take Control Editor 1.0
This article was previously published under Q196101

SYMPTOMS

After you configure the Take Control System Controller (TC1000), you may be unable to rename any of the items the controller is configured to run.

CAUSE

This behavior can occur if your configuration uses the total amount of memory installed in the TC1000.

RESOLUTION

To resolve this behavior, use the following methods:

  • Delete any unused or redundant devices, activities, or macros.
  • Edit the remaining devices to remove any unused buttons.

MORE INFORMATION

To prevent this issue from occurring, do not assign long labels to buttons or rename button labels.

For a description of the maximum capacity of the TC1000, please see the following article in the Microsoft Knowledge Base:

196075 TC1000: Maximum Capacity of the Take Control System Controller

Modification Type:MajorLast Reviewed:7/27/2001
Keywords:kbHardware kbprb KB196101
©2002 Microsoft Corporation. All rights reserved.