Setup Stops Responding While Creating Windows 98 Startup Disk (195621)
The information in this article applies to:
This article was previously published under Q195621 SYMPTOMS
When you attempt to install Windows 98 from MS-DOS, Setup may stop
responding while the Windows 98 Startup disk is being created. The
progress indicator may remain at 20 percent, and the Back, Next, and
Cancel buttons may be unavailable.
CAUSE
This behavior can occur if you click outside of the Insert Disk dialog
box. The Insert Disk dialog box is concealed (blocked from view) by the
Windows 98 Setup Wizard dialog box.
RESOLUTION
To resolve this behavior, move the Windows 98 Setup Wizard dialog box to
reveal the Insert Disk dialog box, and then continue with Setup. To do so,
follow these steps:
- Drag the Windows 98 Setup Wizard dialog box toward the bottom of the
screen until you can see a portion of the Insert Disk dialog box.
- Click the Insert Disk dialog box (do not click OK or Cancel) to bring
it to the foreground.
- Follow the instructions on your screen to continue creating a Startup
disk.
- Drag the Windows 98 Setup Wizard dialog box toward the top of the
screen until you can see the entire dialog box.
- Follow the instructions on your screen to continue with Setup.
MORE INFORMATION
This behavior does not occur if you run Setup from within Windows.
| Modification Type: | Minor | Last Reviewed: | 12/16/2004 |
|---|
| Keywords: | kbprb kbsetup KB195621 |
|---|
|