TV Out on ATI All In Wonder May Not Work Properly (191937)


The information in this article applies to:

  • Microsoft Windows 98
This article was previously published under Q191937
If this article does not describe your hardware-related issue, please see the following Microsoft Web site to view more articles about hardware:

http://support.microsoft.com/default.aspx/w98?sid=460

SYMPTOMS

After you connect a television to your ATI All In Wonder or All In Wonder Pro video adapter, TV Out may not work properly or may be missing from the Display Properties dialog box.

CAUSE

This behavior can occur if you are using a Microsoft Windows 95 video adapter driver, or an inappropriate Windows 98 driver.

RESOLUTION

To support TV Out on an ATI All In Wonder or All In Wonder Pro video adapter, use one of the following methods:


Install the Windows 98 Driver

  1. Click Start, point to Settings, and then click Control Panel.
  2. Double-click Display, click the Settings tab, and then click Advanced.
  3. On the Adapter tab, click Change.
  4. Click Next, click "Display a list of all the drivers in a specific location so you can select the driver you want," and then click Next.
  5. Click Show All Hardware.
  6. In the Manufacturers box, click ATI Technologies.
  7. In the Models box, click the appropriate device, and then click Next.
  8. Click Next.
  9. Click Finish.

Install a Driver from ATI

Obtain and install the appropriate driver from the following ATI Web site:

http://www.atitech.ca



The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Microsoft in no way guarantees the accuracy of this third-party contact information.

Modification Type:MajorLast Reviewed:8/8/2006
Keywords:kbdisplay kbHardware kbprb KB191937
©2004 Microsoft Corporation. All rights reserved.