DSS80: Microphone Slider Appears in Advanced Volume Settings (191659)


The information in this article applies to:

  • Microsoft Digital Sound System 80 1.0
This article was previously published under Q191659

SYMPTOMS

When you use the Advanced Volume Settings utility to adjust the audio settings for your computer, a Microphone slider may appear in the Speaker window. You are, however, unable to change the microphone settings using this slider.

CAUSE

This behavior can occur if the Microsoft Digital Sound System 80 is your preferred playback device.

RESOLUTION

To resolve this issue, adjust the microphone settings in the Master Record window. To do this, follow these steps:

  1. Click Start, point to Settings, and then click Control Panel.
  2. Double-click Multimedia.
  3. Click the Audio tab.
  4. Under Recording, click the icon beside the Preferred Device box.
  5. In the Master Record window, use the Mic Balance and Volume sliders to adjust the microphone settings.
  6. Close the Master Record window.
  7. Click OK, and then close Control Panel.

STATUS

Microsoft has confirmed this to be a problem in the Microsoft products listed in the applies to section of this article.

MORE INFORMATION

To start Advanced Volume Settings, right-click the Digital Sound System 80 icon on the taskbar, and then click Advanced Volume Settings.
Modification Type:MajorLast Reviewed:7/25/2001
Keywords:kbenv kbHardware kbprb kbui KB191659
©2002 Microsoft Corporation. All rights reserved.