Err Msg: Internal Error 45: Your Infrared Software Has... (191578)
The information in this article applies to:
This article was previously published under Q191578 SYMPTOMS
When you double-click the Infrared tool in Control Panel, you may receive
the following error message:
Internal Error 45: Your infrared software has encountered an error,
check infrared software settings under network properties.
CAUSE
This behavior can occur if the Fast Infrared Protocol is missing or
damaged.
RESOLUTION
To resolve this behavior, remove and then reinstall the Fast Infrared
Protocol. To do so, follow these steps:
- Click Start, point to Settings, and then click Control Panel.
- Double-click Network.
- In the list of installed network components, click Fast Infrared
Protocol, and then click Remove.
- Restart your computer when you are prompted to do so.
- Click Start, point to Settings, and then click Control Panel.
- Double-click Network.
- On the Configuration tab, click Add.
- Click Protocol, and then click Add.
- In the Manufactures box, click Microsoft, click Fast Infrared
Protocol in the Network Protocols box, and then click OK.
- Click OK, and then restart your computer when you are prompted to do
so.
MORE INFORMATION
If you install an infrared device in Windows 98, the Fast Infrared
Protocol is not installed by default. You must manually add the protocol
in Network properties.
| Modification Type: | Minor | Last Reviewed: | 12/16/2004 |
|---|
| Keywords: | kberrmsg kbprb KB191578 |
|---|
|