Err Msg: ADPST32 Caused an Invalid Page Fault in Module... (188827)
The information in this article applies to:
- Microsoft Windows 98
- Microsoft Windows 95
This article was previously published under Q188827 If this article does not describe your hardware-related issue, please see the following Microsoft Web site to view more articles about hardware: SYMPTOMS
When you reinstall the Adaptec EZ-SCSI version 4.0x software, you may
receive the following error message:
ADPST32 caused an invalid page fault in module MSCUISTF.dll at
015f:007dlbf7.
After you receive this error message, the computer may stop responding (hang).
CAUSE
This behavior can occur if the following conditions exist:
- An Adaptec 3940UW Dual Channel SCSI adapter is installed on your computer.
- You previously set the Write and Read Cache settings to Enable in
SCSI Explorer (included with EZ-SCSI 4.0x).
- You uninstalled the EZ-SCSI software and then restarted the computer
before attempting to reinstall the EZ-SCSI software.
RESOLUTION
To resolve this issue, follow these steps:
- Restart the computer. When you see the SCSI BIOS information, press
CTRL+A to start the SCSI Setup program.
- In the SCSI Setup program, press the F6 key to restore the factory
default settings. You must do this for both channels.
- Turn your computer off and back on.
- Uninstall and then reinstall the EZ-SCSI software.
MORE INFORMATION
These steps may not work in all cases. If these steps do not resolve the
issue, contact Adaptec for assistance.
The third-party product discussed in this article is manufactured by a
vendor independent of Microsoft; we make no warranty, implied or otherwise,
regarding this product's performance or reliability.
| Modification Type: | Major | Last Reviewed: | 8/8/2006 |
|---|
| Keywords: | kberrmsg kbInvalidPageFault kbprb KB188827 |
|---|
|