Screen Becomes Distorted When Changing Resolution with NEC 4FG (187622)
The information in this article applies to:
This article was previously published under Q187622 If this article does not describe your hardware-related issue, please see the following Microsoft Web site to view more articles about hardware: SYMPTOMS
If you are using an NEC 4FG monitor and you change the display resolution
to 1280x1024 pixels or higher, your screen may become distorted.
CAUSE
This behavior can occur if you are using a video adapter that defaults to
a refresh rate of 60Hz.
RESOLUTION
To resolve this behavior, optimize the refresh rate of your video adapter
before you attempt change the display resolution. To do so, follow these steps:
- Click Start, point to Settings, and then click Control Panel.
- Double-click Display.
- On the Settings tab, click Advanced.
- Click the Adapter tab, and then click Optimal in the Refresh Rate box.
- Click OK, and then click OK when you receive the following message:
Windows will now adjust the refresh rate of your display. The screen
may flicker for a few moments while the settings are being changed.
If the display becomes garbled or unusable, simply wait and Windows
will restore your original settings.
- Click Yes when you are prompted to keep this setting, and then click
OK.
MORE INFORMATION
Some video adapters, such as the Diamond Stealth 64 Video 2001 and S3 Trio
64V+ video adapters, default to a refresh rate of 60Hz. NEC 4FG monitors
can only support refresh rates of less than 60Hz at a resolution of
1280x1024 or higher.
The third-party products discussed in this article are manufactured by
vendors independent of Microsoft; we make no warranty, implied or
otherwise, regarding these products' performance or reliability.
| Modification Type: | Major | Last Reviewed: | 8/8/2006 |
|---|
| Keywords: | kb3rdparty kbdisplay kbenv kbHardware kbprb KB187622 |
|---|
|