PRJ98: Project Stops Responding When Applying AutoFilter (187389)
The information in this article applies to:
- Microsoft Project 98 for Windows
This article was previously published under Q187389 SYMPTOMS
When you apply an AutoFilter, Microsoft Project may stop responding, and
you may receive one of the following error messages.
In Windows 95
This program has performed an illegal operation and will be shut down. If the Problem persists, contact the program vendor.
If you click Details, you receive the following error message:
WINPROJ caused an invalid page fault in module WINPROJ.EXE at <address>.
In Windows NT
An application error has occurred and an application error log is being generated.
Exception access violation (0xc0000005), Address <address>.
CAUSE
This problem occurs when you use an AutoFilter on a column with more than approximately 10,000 rows of data.
NOTE: To turn on the AutoFilter, point to Filtered For on the Project menu, and then click AutoFilter. To use AutoFilter, click the arrows next to the column titles.
RESOLUTION
To correct this problem, install Microsoft Project 98 for Windows Service
Release 1 (SR-1).
STATUSMicrosoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.
This problem was corrected in Microsoft Project 98 for Windows, Service
Release 1 (SR-1).
For additional information about obtaining and installing SR-1, click the
article number below to view the article in the Microsoft Knowledge Base:
185102
PRJ98: How to Obtain and Install MS Project 98 SR-1
| Modification Type: | Major | Last Reviewed: | 10/17/2002 |
|---|
| Keywords: | kbbug kberrmsg KB187389 |
|---|
|