Err Msg: A Device Driver or Program Will Not Let Your System... (187323)


The information in this article applies to:

  • Microsoft Windows 98
This article was previously published under Q187323

SYMPTOMS

When you attempt to put Windows 98 in Standby mode by clicking Start, clicking Shut Down, clicking Stand By, and then clicking OK, you may receive the following error message:
A device driver or program will not let your system enter Stand By mode.

CAUSE

This behavior can occur if Diamond Multimedia/NetCommander ISDN adapter drivers are installed on your computer. These drivers prevent Windows 98 from going into Standby mode.

RESOLUTION

To resolve this issue, contact Diamond Multimedia Technical Support to inquire about the availability of updated drivers.

MORE INFORMATION

For information about how to contact Diamond Multimedia, query in the Microsoft Knowledge Base for one of the following articles:

ARTICLE-ID: 65416
TITLE : Hardware and Software Third-Party Vendor Contact List, A-K


ARTICLE-ID: 60781
TITLE : Hardware and Software Third-Party Vendor Contact List, L-P


ARTICLE-ID: 60782
TITLE : Hardware and Software Third-Party Vendor Contact List, Q-Z



The third-party product discussed in this article is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.
Modification Type:MinorLast Reviewed:12/16/2004
Keywords:kb3rdparty kberrmsg kbPowerMan kbprb KB187323
©2004 Microsoft Corporation. All rights reserved.