Invalid Command Line Argument Using NAI Nuts & Bolts DiskMinder (187290)
The information in this article applies to:
This article was previously published under Q187290 SYMPTOMS
When you start your computer after improperly shutting it down, you may
receive an NAI Nuts & Bolts DiskMinder error message that says an invalid
command line argument was used.
CAUSE
This behavior can occur if you are using the NAI Nuts & Bolts DiskMinder
program instead of ScanDisk as your disk repair program. NAI Nuts & Bolts
DiskMinder is unable to correctly interpret the /simpleui switch used
with ScanDisk in the Win.com file.
RESOLUTION
To work around this issue, ignore the error message, and DiskMinder can
then continue normally.
STATUS
The third-party products discussed here are manufactured by vendors
independent of Microsoft; we make no warranty, implied or otherwise,
regarding these products' performance or reliability.
| Modification Type: | Minor | Last Reviewed: | 12/16/2004 |
|---|
| Keywords: | kbprb KB187290 |
|---|
|