Err Msg: RNAAPP Caused an Invalid Page Fault in Module <Unknown> (182589)


The information in this article applies to:

  • Microsoft Windows 95
This article was previously published under Q182589

SYMPTOMS

When you double-click a Dial-Up Networking connection, you may receive one of the following error messages:
RNAAPP caused an invalid page fault in module <unknown>.
Msimn caused an invalid page fault in module <unknown>.

CAUSE

This error message can occur if Quarterdeck CleanSweep Deluxe is installed on your computer.

RESOLUTION

To work around this behavior, follow these steps:
  1. Click Start, click Shut Down, click Restart In MS-DOS Mode, and then click OK.
  2. Type the following commands, pressing ENTER after each command:

    cd progra~1\quarte~1\cleans~1
    ren csinject.exe csinject.xxx
    exit

NOTE: Renaming the Csinject.exe file causes Quarterdeck SmartSweep not to automatically start when you start Windows. You must manually start SmartSweep to monitor the installation of any programs using CleanSweep.

MORE INFORMATION

For additional information about this issue, contact Quarterdeck Technical Support. For information about how to contact Quarterdeck, query in the Microsoft Knowledge Base for one of the following articles:

65416 Hardware and Software Third-Party Vendor Contact List, A-K

60781 Hardware and Software Third-Party Vendor Contact List, L-P

60782 Hardware and Software Third-Party Vendor Contact List, Q-Z


The third-party product discussed in this article is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.
Modification Type:MajorLast Reviewed:7/28/2001
Keywords:kb3rdparty kbDialUp kberrmsg kbprb KB182589
©2002 Microsoft Corporation. All rights reserved.