OL98: Grid Displayed in Form Control Outside of Design Mode (180900)
The information in this article applies to:
This article was previously published under Q180900 SYMPTOMS
If you use Microsoft Outlook 98 to create a custom form that includes a
control, the control's grid may continue to appear after you quit design
mode. This behavior usually occurs with the Frame or MultiPage control.
WORKAROUND
Follow these steps to stop the grid from appearing when you are out of
design mode:
- Open the form.
- On the Tools menu, point to Forms, and then click Design This Form.
- Right-click the control that displays the grid.
- Click to clear the Show Grid check box.
- On the Form menu, click Run This Form.
STATUS
Microsoft has confirmed this to be a problem in the products listed at the
beginning of this article. Microsoft is researching this problem and will
post new information here in the Microsoft Knowledge Base as it becomes
available.
MORE INFORMATION
Outlook forms exhibit this behavior when you turn off the form's grid and
turn on the control's grid before exiting design mode. Any toolbox control
capable of displaying a grid can have this problem.
REFERENCES
For more information about creating solutions with Microsoft Outlook 98,
please see the following articles in the Microsoft Knowledge Base:
180826 OL98: Resources for Custom Forms and Programming
182349 OL98: Questions About Custom Forms and Outlook Solutions
Modification Type: | Minor | Last Reviewed: | 3/1/2004 |
---|
Keywords: | kbbug kbnofix kbprogramming KB180900 |
---|
|