Problems If Screen Saver Password Is More Than 14 Characters (180438)
The information in this article applies to:
- Microsoft Windows 95
- Microsoft Windows 95 OEM Service Release 2
- Microsoft Windows 95 OEM Service Release 2.1
This article was previously published under Q180438 SYMPTOMS
If you specify a screen saver password that contains more than 14
characters, one of the following symptoms may occur:
- If the password contains 15 to 19 characters, the Windows Screen Saver
dialog box does not appear when you try to stop the screen saver.
As a result, you can stop the screen saver without typing the screen
saver password.
- If the password contains more than 19 characters, your computer stops
responding (hangs), or you receive the following error message when you
try to set the screen saver password:
MPREXE caused an invalid page fault in module
MPRSERV.DLL at <address>.
CAUSE
This problem can occur if the screen saver password is copied into an
improperly sized internal buffer. If this occurs, internal status code
values and values that are currently stored in memory may be damaged,
leading to the symptoms described earlier.
RESOLUTIONSTATUS
This problem no longer occurs in Windows 98. To resolve this problem, install the current version of Windows. For information about the current version of Windows, visit http://www.microsoft.com/windows.
MORE INFORMATION
This problem only affects the initial processing of a new screen saver
password. Passwords up to 14 characters in length function properly.
| Modification Type: | Minor | Last Reviewed: | 9/22/2005 |
|---|
| Keywords: | kbHotfixServer kbQFE kbenv kberrmsg kbprb KB180438 |
|---|
|