How to write an Lmhosts file for domain validation and other name resolution issues (180094)

MORE INFORMATION

To create a correctly formatted Lmhosts file, follow these steps:

1. Use any text editor, such as Notepad.exe or Edit.com, to create a file named Lmhosts, and save it in the following folder:

         Microsoft Windows NT
         ----------
   
         %SystemRoot%\System32\Drivers\Etc
   
         Microsoft Windows 95
         ----------
   
         C:\Windows (the folder where Windows is installed)
   
         Microsoft Windows NT and Windows 2000
         ---------------------------
   
         %SystemRoot%\System32\Drivers\Etc
   						

   Note The file name is Lmhosts, without an extension. If you use Notepad.exe, it may automatically append the .txt extension. In this case, at a command prompt, you must rename the file using no extension.
2. Add the following entries to the Lmhosts file:

         10.0.0.1   PDCNAME   #PRE #DOM:DOMAIN-NAME
         10.0.0.1   "DOMAIN-NAME    \0x1b"   #PRE
   					

   Note The domain name in this entry is case sensitive. Make sure that you use uppercase characters for the domain name. If you use lowercase characters for the domain name, NetBT does not recognize the name.

Note Make sure that you space these entries correctly. Replace 10.0.0.1 with the IP address of your primary domain controller (PDC). Replace PDCName with the NetBIOS name of your PDC, and replace domain with your Windows NT domain name. There must be a total of 20 characters within the quotations (the domain name plus the appropriate number of spaces to pad up to 15 characters, plus the backslash, plus the NetBIOS hex representation of the service type).

To help determine where the sixteenth character is, copy the following line to your Lmhosts file:

      # IP Address    "123456789012345*7890"
				

Line up the double quotation marks (") by adding or removing spaces from the comment line, and put the \ on the sixteenth column (the column marked with the asterisk). You must use spaces after the name and before the \, not a tab.

For additional information, click the following article number to view the article in the Microsoft Knowledge Base:

1. After you add the lines, save the file, and exit the editor.
2. At a command prompt, type nbtstat -R, and then press ENTER.
   
   Note The -R is case sensitive and must be uppercase. After you type this text, you should receive the following message: Successful purge and preload of the NBT Remote Cache Name Table.
3. At a command prompt, type nbtstat -c, and then press ENTER.
   
   Note The -c is case sensitive and must be lowercase. After you type this text, you should receive a display that is similar to the following:

         Node IpAddress: [10.0.0.5] Scope Id: []
   
                      NetBIOS Remote Cache Name Table
   
            Name              Type       Host Address    Life [sec]
         ----------------------------------------------------------
         PDCName        <03>  UNIQUE      10.0.0.1           -1
         PDCName        <00>  UNIQUE      10.0.0.1           -1
         PDCName        <20>  UNIQUE      10.0.0.1           -1
         Domain         <1B>  UNIQUE      10.0.0.1           -1
   						

For additional information, click the following article number to view the article in the Microsoft Knowledge Base: