PRB: "Insert the CD Labeled Microsoft VFP Setup CD-Rom" Error (179196)
The information in this article applies to:
- Microsoft Visual FoxPro for Windows 5.0
- Microsoft Visual FoxPro for Windows 5.0a
This article was previously published under Q179196 SYMPTOMS
WARNING: The information in this article has not been confirmed or tested
by Microsoft. Some or all of the information in this article has been taken
from unconfirmed customer reports. ANY USE BY YOU OF THE INFORMATION
PROVIDED IN THIS ARTICLE IS AT YOUR OWN RISK. Microsoft provides this
information "as is" without warranty of any kind, either expressed or
implied, including but not limited to the implied warranties of
merchantability and/or fitness for a particular purpose.
When you install the Visual FoxPro for Windows 5.0 component from Visual
Studio 97, the installation may be interrupted with the following error
message:
Insert the CD Labeled Microsoft VFP Setup CD-ROM.
A warning dialog box appears with OK and Cancel buttons. Selecting the OK
button allows the installation to continue but the process will be
interrupted again with either the same or a different error message.
CAUSE
You are using the Backpack external CD-ROM parallel port real-mode driver.
RESOLUTION
Current Backpack CD-ROM drive models can use a 32-bit protected-mode driver
that can be obtained from the manufacturer for compatibility with Windows
95 and Windows NT 3.51 and 4.0. This driver can be downloaded from the
Software Library at Micro Solutions' Web site at:
REFERENCES
For more information about the Backpack CD-ROM driver, please see the
following article in the Microsoft Knowledge Base:
131499 CD-ROM Drives Requiring Real-Mode Drivers
| Modification Type: | Major | Last Reviewed: | 8/20/1999 |
|---|
| Keywords: | kbprb KB179196 |
|---|
|