XL98: "Cannot Change Part of a Merged Cell" Error When You Drag a Merged Cell Over Another Merged Cell (178771)


The information in this article applies to:

  • Microsoft Excel 98 Macintosh Edition
This article was previously published under Q178771

SYMPTOMS

When you drag and drop a merged cell in Microsoft Excel 98 Macintosh Edition, you may receive the following error message:
Cannot change part of a merged cell.

CAUSE

This error message occurs if either of the following conditions is true:
  • The location to which you are dragging the merged cell overlaps the original location of the merged cell. -or-

  • The location to which you are dragging the merged cell overlaps another merged cell without completely covering it.
NOTE: If the new location of the merged cell completely covers another merged cell, the error message does not occur.

RESOLUTION

To prevent this error message from occurring, make sure that when you drag and drop a merged cell, the new location of the merged cell does not overlap any existing merged cells without completely covering them.

MORE INFORMATION

Microsoft Excel 98 Macintosh Edition includes a new feature that enables you to merge a range of cells into a single, merged cell. To use this feature, select the cells that you want to merge, and then perform either of the following steps:
  • On the Format menu, click Cells. On the Alignment tab, click to select the Merge Cells check box, and then click OK. -or-

  • Click the Merge And Center button on the Formatting toolbar.
Modification Type:MajorLast Reviewed:9/11/2002
Keywords:kbprb KB178771
©2002 Microsoft Corporation. All rights reserved.