FIX: Unattended Setup Disables EnableDHCPFlag on Second Adapter (177267)

RESOLUTION

1. On your distribution share, expand the Oemnxptc.in_ file by typing the following at the command prompt:
   
   Expand Oemnxptc.in_ Oemnxptc.inf
2. Rename the compressed Oemnxptc.in_ file to Oemnxptc.sav.
   
   This step is required because this not only offers a backup copy of the file but the setup program will always use the compressed version of the file if both are present.
3. Use any text editor to modify the following section of the .inf file:
   
   Before modifications are made:
   

   [InstallOption]
   set Option   = $($1)
   set SrcDir   = $($2)
   set AddCopy  = $($3)
   set DoCopy   = $($4)
   set DoConfig = $($5)
   set InstallFromRas = $($6)
   set EnableDHCPFlag = $($7)
   set InstallList = $($8)
   ifstr(i) $(EnableDHCPFlag) == ""
   set EnableDHCPFlag = 0
   Debug-Output "DHCP Phase 1 Flag :"$(EnableDHCPFlag)
   Debug-Output "DHCP Phase 1 Adapter :"$(EnableDHCPForThisAdapter)
   endif
   ifstr(i) $(InstallList) == ""
   set InstallList = {"1","1","0","0","0","0","0","0"}
   						

   
   After modification are made:
   

   [InstallOption]
   set Option   = $($1)
   set SrcDir   = $($2)
   set AddCopy  = $($3)
   set DoCopy   = $($4)
   set DoConfig = $($5)
   set InstallFromRas = $($6)
   set EnableDHCPFlag = $($7)
   set InstallList = $($8)
   ifstr(i) $(EnableDHCPFlag) == ""
   set EnableDHCPFlag = 0
   ;**************modified code begins here****************
   Ifstr(i) $(!STF_GUI_UNATTENDED) == YES
   set EnableDHCPFlag = 1
   endif
   ;**************Modifications end here******************
   Debug-Output "DHCP Phase 1 Flag :"$(EnableDHCPFlag)
   Debug-Output "DHCP Phase 1 Adapter :"$(EnableDHCPForThisAdapter)
   endif
   ifstr(i) $(InstallList) == ""
   set InstallList = {"1","1","0","0","0","0","0","0"}
   						

4. Save the file and begin your unattended setup.