FIX: Controls on Nested Frames on SSTab May Paint Incorrectly (176430)


The information in this article applies to:

  • Microsoft Visual Basic Learning Edition for Windows 5.0
  • Microsoft Visual Basic Professional Edition for Windows 5.0
  • Microsoft Visual Basic Enterprise Edition for Windows 5.0
This article was previously published under Q176430

SYMPTOMS

Controls located inside two nested frames located on an SSTab control may not repaint correctly at run-time when resized if the SSTab control they are located on was made visible immediately prior to resizing the control. The incorrect repaint varies by control, but ranges from lack of a border to not being visible at all.

RESOLUTION

Two workarounds exist:
  • Make sure that controls located on nested frames on an SSTab are resized before rather than after making the SSTab visible.

    -or-
  • Add the following code after resizing the controls: 
          SSTab1.Visible = False
      SSTab1.Visible = True

STATUS

Microsoft has confirmed this to be a bug in the Microsoft products listed at the beginning of this article. This bug has been fixed in Visual Studio 97 Service Pack 2.

For more information on the Visual Studio 97 Service Pack 2, please see the following article in the Microsoft Knowledge Base:

170365 : INFO: Visual Studio 97 Service Packs - What, Where, and Why


For a list of the Visual Basic 5.0 bugs that were fixed in the Visual Studio 97 Service Pack 2, please see the following article in the Microsoft Knowledge Base:

171554 : INFO: Visual Basic 5.0 Fixes in Visual Studio 97 Service Pack 2

MORE INFORMATION

Steps to Reproduce Behavior

  1. Start a new Standard EXE project. Form1 is created by default.
  2. Add an SSTab (SSTab1 by default) to Form1.
  3. Draw a Frame control (Frame1 by default) on Tab0 of SSTab1 so that it is contained by Tab0.
  4. Draw another Frame control (Frame2 by default) inside Frame1 so that it is contained by Frame1.
  5. Draw a TextBox (Text1 by default) inside of Frame2 so that it is contained by Frame2.
  6. Add a CommandButton (Command1 by default) to Form1.
  7. Paste the following code in the General Declarations section of Form1: 
          Private Sub Command1_Click()

         SSTab1.Visible = False  'this could happen in form load, or any
                                 'other event.

         SSTab1.Visible = True            'one workaround is to switch
         Text1.Width = Text1.Width - 50   'the order of these two lines


        'alternate workaround if above workaround is not feasible
        'SSTab1.Visible = False
        'SSTab1.Visible = True

      End Sub
Modification Type:MajorLast Reviewed:11/18/2003
Keywords:kbbug kbfix KB176430
©2003 Microsoft Corporation. All rights reserved.