XCON: Configuration Sample - Exchange X.400 Connector & Infonet (175483)

MORE INFORMATION

To successfully connect Microsoft Exchange Server and Infonet by an X.400 connector, both sides of the connection must be configured properly. The following sample configuration is intended to be used only as a guideline. Your configuration will vary.

Exchange Server Connection Information

Exchange MTA name : Highlanders
Exchange TSAP : None
Exchange IP address : 200.200.200.1

Infonet Connection Information

INFONET MTA name : Infonet
Infonet TSAP : 1032 (text value)
Infonet IP Address : 200.200.200.10

Exchange Server Configuration Example

TCP/IP Transport stack values

TSEL
SSEL
PSEL

X.400 Connector Properties

General Tab:

Remote MTA Name : Infonet
Remote MTA Password : no password used.

Stack tab:

IP address : 200.200.200.10 "This is the Infonet IP address."

(Outgoing OSI Information)

T selector : 1032 (Display in text)
S selector :
P selector :

(Incoming OSI Information)

T selector : 1032
S selector :
P selector :

Override Tab:

All left in default values. Local MTA name may be used if the Infonet MTA refers to the Exchange Server MTA by a name other than the Windows NT server name. This configuration does not use any override values.

Advanced TAB:

MTA conformance: 1988 normal mode
X.400 Link options: Allow BP-15 (in addition to BP-14)
Two way alternate: unchecked
Allow Msexchange Content: Unchecked

Address Space:

Address space should contain the routing information. For example:

      C=us;a=test;p=infonet;

Connected Site:

This entry should be left blank. Connected sites are used between Exchange Server sites only.

Infonet Configuration Example

This file is the configuration file, residing on the Infonet side and defining the connection to the Exchange Server MTA.

   mtamaint: print conn
   Entry Name : HIGHLANDERS
   Connection : HIGHLANDERS
   Status : enabled
   Operating Hours : 00:00-23:59
   Cost : 0
   Out Connection Info:
   dm=mono,rts=88,pp=on,rpsap="1032"/Internet=200.200.200.1,
   lpsap="1032"/Internet=200.200.200.10,cp=30,wn=5

   Enable Alternate : true
   In Connection Info: dm=mono,rts=88,rpsap=Internet=200.200.200.1,
   lpsap=Internet=200.200.200.10,cp=30,wn=5

   Comment: This is the new connection to Microsoft Exchange Server MTA.

   mtamaint: print mta
   Entry Name: HIGHLANDERS
   MTA: HIGHLANDERS
   Queue File: _HIGHLANDERS
   Queue Size: 0 (rep=0 high=0 normal=0 low=0 def=0)
   Cost: 0
   Management Domain: C=us/ADMD=test/PRMD=highlanders/ 
   Connection: highlanders
   Protocol: 88p1
   Schedule Info: high=-1:0:0:E,normal=-1:0:0:E,low=-1:0:0:E,report=-1:0:0:
   E,poll=1:0:0:E,any=0:0:0:E,max_txps=1

   Comment: New MTA name

Domain routing segment Route

C=us/ADMD=test/PRMD=highlanders/ HIGHLANDERS
C=us/ADMD=test/PRMD=infonet @local