Stop 0x0000000A in Atapi.sys (Post SP2) with DMA Enabled (174232)
The information in this article applies to:
- Microsoft Windows NT Workstation 4.0
- Microsoft Windows NT Server 4.0
This article was previously published under Q174232 SYMPTOMS
When you use DMA Bus-Mastering on a PCI IDE controller using Atapi.sys
(Service Pack 2 or later) you may experience the following blue screen
error message:
Stop 0x0000000A (0x00830830, 0x0000000d, 0x00000001 0x800059f0)
IRQL_NOT_LESS_OR_EQUAL
Address 800059f0 has base at 80005000 - ATAPI.SYS
NOTE: The first parameter will vary and the fourth parameter will always
fall in the range of Atapi.sys.
CAUSE
This is caused when the buffer provided to Atapi is in user-mode and the
driver not running in the same context, accesses the buffer. This happens
specifically with the inquiry command using pass-through-direct mode.
WORKAROUND
Disable DMA Bus-Mastering for Atapi or contact the manufacture of the
application for an update or rewrite the application to use
IOCTL_SCSI_PASS_THROUGH.
For more information on DMA Bus-Mastering, please refer to the following
Microsoft Knowledge Base article:
ARTICLE-ID: 158873
TITLE : How to Enable IDE DMA Bus-Mastering using SP2 ATAPI.SYS
MORE INFORMATION
This is a design problem that has been seen with applications that use the
SCSIOP_INQUIRY commands to the miniport through the
IOCTL_SCSI_PASS_THROUGH_DIRECT interface. In order to send
IOCTL_SCSI_PASS_THROUGH_DIRECT you must be an administrator. This IOCTL
should not be used to send a SCSIOP_INQUIRY.
| Modification Type: | Minor | Last Reviewed: | 9/23/2005 |
|---|
| Keywords: | kbHotfixServer kbQFE kbbug kbfix KB174232 |
|---|
|