SMS: Exception 0E May Be Caused When Unloading Remote Control Agent (174134)


The information in this article applies to:

  • Microsoft Systems Management Server 1.2
This article was previously published under Q174134
IMPORTANT: This article contains information about editing the registry. Before you edit the registry, make sure you understand how to restore it if a problem occurs. For information about how to do this, view the "Restoring the Registry" Help topic in Regedit.exe or the "Restoring a Registry Key" Help topic in Regedt32.exe.

SYMPTOMS

If the Remote Control agent (Wuser.exe) is unloaded during an active Remote Control session, an exception 0E error may occur under Windows 95.

CAUSE

If the protocol used for Remote Control uses a NetBIOS interface, the symptom described above can occur, sometimes sporadically. When using Remote Control with NetBIOS over TCP/IP (NetBT), you will receive the following message:
An exception 0E occurred at xxx:xxxxxxxx in VxD VNBT(01)
Although the message indicates that you may be able to continue normally, the current Windows 95 session must be stopped and then restarted.

WORKAROUND

To work around this problem, use a sockets-based transport for Remote Control.

You can change the default Remote Control protocol on a per-client basis or on a site-wide basis. To change a client's Help Desk protocol from NetBIOS to either IP sockets or IPX sockets, you must modify the client's Sms.ini file. To do this, perform either of the sets of steps below, depending on if you want to perform the modification on a by-client or site-wide basis:

Client-by-Client Basis

  1. Stop the Remote Control agent.
  2. Open the Sms.ini file in a text editor such as Notepad.
  3. Find the [SIGHT] section and locate the "Default Protocol=NetBIOS" line.
  4. Change this value from NetBIOS to either IP or IPX, depending on the network protocol in use.

Site-Wide Basis

To make all clients in this domain use IP sockets (except for client computers running Windows NT, which do this by default) or IPX sockets, you must make a registry change at the site server.

WARNING: Using Registry Editor incorrectly can cause serious problems that may require you to reinstall your operating system. Microsoft cannot guarantee that problems resulting from the incorrect use of Registry Editor can be solved. Use Registry Editor at your own risk.

For information about how to edit the registry, view the "Changing Keys And Values" Help topic in Registry Editor (Regedit.exe) or the "Add and Delete Information in the Registry" and "Edit Registry Data" Help topics in Regedt32.exe. Note that you should back up the registry before you edit it.

To make the registry change, perform the following steps:

  1. Start Registry Editor (Regedt32.exe).
  2. Go to the following key in the registry:
          HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\SMS\Sites\<Sitecode>
      \Domains\<Domain>
  3. Set the Default RC Protocol (REG_SZ) value to IP or IPX, depending on the network protocol in use.
This procedure forces all client computers running Windows 3.1, Windows for Workgroups, or Windows 95 that appear in this domain to use IP sockets as the default Remote Control protocol.

STATUS

Microsoft has confirmed this to be a problem in Systems Management Server version 1.2. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.
Modification Type:MinorLast Reviewed:6/14/2005
Keywords:kbbug kbnetwork kbRemoteProg kbtshoot KB174134
©2004 Microsoft Corporation. All rights reserved.