FIX: Run-time Error 6 "Overflow When Compiled to Native Code" (171837)


The information in this article applies to:

  • Microsoft Visual Basic Control Creation Edition for Windows 5.0
  • Microsoft Visual Basic Learning Edition for Windows 5.0
  • Microsoft Visual Basic Professional Edition for Windows 5.0
  • Microsoft Visual Basic Enterprise Edition for Windows 5.0
This article was previously published under Q171837

SYMPTOMS

The following error may occur when the if expression uses Byte data type:
"Run-time error '6'. Overflow."

CAUSE

Visual Basic does not evaluate Byte data type correctly in the if expression when compiled to Native code with optimizations.

RESOLUTION

Install Visual Studio 97 Service Pack 2 (SP2). The problem can also be addressed by compiling to P-code, compiling to Native Code with no optimizations, or using a data type other than the byte data type in the if expression.

STATUS

Microsoft has confirmed this to be a bug in the Microsoft products listed at the beginning of this article. This bug has been fixed in Visual Studio 97 Service Pack 2.

For more information on the Visual Studio 97 Service Pack 2, please see the following article in the Microsoft Knowledge Base:

170365 : INFO: Visual Studio 97 Service Packs - What, Where, and Why


For a list of the Visual Basic 5.0 bugs that were fixed in the Visual Studio 97 Service Pack 2, please see the following article in the Microsoft Knowledge Base:

171554 : INFO: Visual Basic 5.0 Fixes in Visual Studio 97 Service Pack 2

MORE INFORMATION

The following code (known as the "Triangle Inequality") will run as expected in the Visual Basic IDE or compiled as P-code but will fail when compiled as a Native EXE file with optimizations.

Steps to Reproduce Behavior

  1. Start a New Standard EXE project. Form1 is created by default.
  2. In the General Declarations section of Form1, place the following code: 
          Sub Checksides (a as Byte, b as Byte, c as Byte)

          If (c > a + b) or (a > b + c) or (b > a + c) then
              MsgBox "Not a triangle"
          Else
              MsgBox "Triangle"
          End If

      End Sub
  3. In the Form_Load() event of Form1, place the following code: 
          Private Sub Form_Load()
        CheckSides 1,1,1
        End
      End sub
  4. Select Project Properties from the Project menu. Open the Compile tab and make sure the project is set to compile to Native Code with some sort of optimization selected, such as Optimize for fast code.
  5. Select Make Project1.exe from the File Menu.
  6. Execute the Project1.exe file.
This will produce the error message "Run-time error 6. OverFlow."
Modification Type:MajorLast Reviewed:12/10/2003
Keywords:kbbug kbfix kbvbp500sp2fix kbVS97sp2fix KB171837
©2003 Microsoft Corporation. All rights reserved.