The "REPORT FORM TO FILE" command launches a WinFax application in Visual FoxPro for Windows (171266)


The information in this article applies to:

  • Microsoft Visual FoxPro for Windows 3.0
  • Microsoft Visual FoxPro for Windows 3.0b
  • Microsoft Visual FoxPro for Windows 5.0
  • Microsoft Visual FoxPro for Windows 5.0a
  • Microsoft Visual FoxPro for Windows 6.0
This article was previously published under Q171266

SYMPTOMS

In Visual FoxPro, issuing a "REPORT FORM TO FILE" command sends the contents of the report to a file with the selected printer driver's control codes. The file can then be copied to the selected printer. With WinFax (version 8.0) selected as the printer, issuing a "REPORT FORM TO FILE" command behaves the same if REPORT FORM to PRINTER. Rather than going to a file, WinFax is launched and the report is sent as a fax.

Note This problem does not seem to occur with Visual FoxPro 7.0, 8.0, and 9.0 when using WinFax Pro 10.

MORE INFORMATION

Steps to Reproduce Behavior

  1. Install WinFax 8.0. WinFax should appear as a Printer option.
  2. In Visual FoxPro, create and save a report as "FAXTEST." Select "WinFax" as the printer from the File, Page Setup menu option.
  3. From the Command window, issue the following code: 
          REPORT FORM faxtest TO FILE test.fax
The WinFax application starts and proceeds to process the report as if it had been sent to PRINTER rather than send the report to a file.
Modification Type:MajorLast Reviewed:2/16/2005
Keywords:kbprb KB171266
©2004 Microsoft Corporation. All rights reserved.