Range Of LUs Wizard Should Use 2 Digits if Base is Hexadecimal (165128)
The information in this article applies to:
This article was previously published under Q165128 SYMPTOMS
When setting up a range of LUs, if you add the LUs with leading zeros,
Manager will create the LUs with three characters. This should not be an
issue for most users, but may cause a problem if your base LU name contains
six characters.
NOTE: If you are using decimal you will be limited to a five character base
name when using leading zeros. If you have less than 100 LUs you can use a
six character base name without leading zeros.
RESOLUTION
The wizard was modified so that it only adds two hex digits to the LU name
base.
To resolve this problem, obtain the hotfix mentioned below.
The modified file is:
<Snaroot>\System\Snawiz.dll
STATUS
Microsoft has confirmed this to be a problem in SNA Server version 3.0.
This problem was corrected in the latest Microsoft SNA Server 3.0 U.S.
Service Pack. For information on obtaining the service pack, query on
the following word in the Microsoft Knowledge Base (without the spaces):
| Modification Type: | Major | Last Reviewed: | 10/22/2003 |
|---|
| Keywords: | kbbug kbfix kbnetwork KB165128 |
|---|
|