SNA Server Issues with DBCS 3270 Printing (165023)

SYMPTOMS

1. DBCS Characters Incorrect and Multiple Sessions Fail.
   
   SYMPTOMS
   
   DBCS characters do not print correctly in both LU1 and LU3 datastreams, and a Dr. Watson log is generated whenever multiple print sessions are activated.
   
   
   • DBCS characters are not printed correctly in LU3. ShiftOut(0x0E) and ShiftIn(0x0F) are not handled correctly. These codes mark the beginning and end of DBCS data. Because these codes are not recognized, DBCS characters between SO(0x0E) and SI(0x0F) are printed as two single byte character set (SBCS) characters.
   • Dr.Watson errors appear on activations of multiple printer sessions. If only one DBCS code page session is activated, the problem does not occur. However, if two or more DBCS code page sessions are activated, a Dr. Watson error occurs.
   • DBCS characters are not printed correctly in LU1. If DBCS data containing one or more control codes (NL, CR, LF, BS, and so on) is sent, the DBCS data is printed incorrectly.
   
   
   RESOLUTION
   
   To resolve these problems, obtain the hotfix mentioned in the STATUS section of this article.
2. Multiple Fixes for DBCS SCS Printing.
   
   SYMPTOMS
   
   There were multiple problems found in DBCS SCS printing. The following problems were reported:
   
   
   1. When the margin is set in the Printing tab of the Printer Session Properties Printing tab, the position of the grid line is incorrect.
   2. The grid line is incorrect on some control codes.
   3. The automatic line feed (LF) is not performed. This automatic LF is a special function for the grid handling (for DBCS code page only).
   4. "-R" is not returned on incomplete Set Attribute (SA) Datastreams.

               Complete SA format:
                  DBCS: 0x'2843xx'
                  Grid: 0x'28C2xx'
               Incomplete SA:
                  The data chain ends with 0x'28' or 0x'2843' or 0x'28C2'.

   5. New line (NL) is not performed after Maximum Presentation Position (MPP).
   6. NUL control code is printed.
   
   
   STEPS
   
   To resolve these problems, obtain the hotfix mentioned in the STATUS section of this article. With the hotfix:
   
   
   1. The printing position of the grid was adjusted for the margin.
   2. The grid handling after some control codes(NL, CR, LF, BS, and so on) was modified.
   3. The automatic LF process for the grid has been corrected.
   4. For the incomplete SA format, -R is set at the end of the data chain.
   5. The NL process for MPP has been corrected.
   6. The NUL character was translated to space.