DEC Celebris 590 with Buslogic KT-946C May Hang (164664)


The information in this article applies to:

  • Microsoft Windows NT Workstation 4.0
  • Microsoft Windows NT Server 4.0
This article was previously published under Q164664

SYMPTOMS

After you apply Windows NT 4.0 Service Pack 2 on a DEC Celebris 590 with buslogic KT-946C, the computer appears to stop responding when restarted.

CAUSE

A problem in Atapi.sys driver was causing other peripheral component interface (PCI) devices to not respond as expected after enumerating the PCI bus (how they do not respond as expected depends on the device.)

STATUS

Microsoft has confirmed this to be a problem in Windows NT version 4.00.

A supported fix is now available, but has not been fully regression tested and should be applied only to systems experiencing this specific problem. Unless you are severely impacted by this specific problem, Microsoft recommends that you wait for the next Service Pack that contains this fix. Contact Microsoft Technical Support for more information.
Modification Type:MajorLast Reviewed:8/8/2001
Keywords:kbbug KB164664
©2002 Microsoft Corporation. All rights reserved.