FIX: ODBC Files Get Copied to Distribution Disks in VFP 3.0 (164389)

RESOLUTION

To ensure that these files do not get copied onto the disk images, complete the following steps:

1. Delete the Visual FoxPro \Distrib directory.
2. Open the Compress.dbf table in the Visual FoxPro \Distrib.src directory and make a backup of it.
3. Create an index on the DEST field. Locate Odbc.dl_ in the DEST field. Move the record pointer to that record.
4. Issue the following command in the Command window:

         DELETE NEXT 52
   						

   Browse the table to make sure that only names that start with OD in the DEST field are marked for deletion. There might be more than 52 records that start with OD. If so, mark them for deletion also.
5. Now that the ODBC files are marked for deletion in the Compress table, pack the table and close it.
6. Delete the Compress and Disk images directories under the destination directory if they have been created from an earlier session of the Setup Wizard. Also delete the Dkcontrl.dbf, Dkcontrl.cdx, and Wzsetup.ini files located in the directory where the source files are.
7. Run the Setup Wizard to rebuild the Visual FoxPro \Distrib directory and the Disk images directories. Note that opening up each of the disk images shows that there are no ODBC files now.
8. Open the Setup.st1 file in the DISK1 directory with Notepad and place a semicolon at the beginning of any line that represents an ODBC file. The semicolon acts as a remark statement allowing the setup routine to bypass that line. This step has to be repeated every time the Disk images are re-created.

To be able to change back to checking the ODBC drivers check box in the Setup Wizard and loading the ODBC files into the Disk images directories, replace the Compress.dbf file in the Visual FoxPro \Distrib.src directory with the backup that was created and delete the Visual FoxPro \Distrib directory. Running the Setup wizard re-creates the Distrib directory and add the ODBC files to the Disk images.