Trap in Snalink.exe( _bm_rel@04 ) with DCA ISCA X.25 Adapter (162618)
The information in this article applies to:
- Microsoft SNA Server 2.11 SP1
This article was previously published under Q162618 SYMPTOMS
If you run SNA Server version 2.11 Service Pack 1 (SP1) on Windows NT 3.5
(without any Windows NT service packs), you may experience a trap in
Snalink.exe (in function _bm_rel@04) when using a DCA ISCA X.25 adapter.
The problem may be encountered if a TP fails to start because it hits a
time out condition while waiting for a response from the network. If the
administrator then shuts down the computer running SNA Server in an attempt
to reinitialize the system, SNA Server may return Event ID 624, indicating
that a software component has trapped.
CAUSE
The X25 link service was trapping on termination because the code was
attempting to free a buffer twice.
RESOLUTION
Apply the fix referenced below. The updated module is Ibmx25.dll.
STATUS
Microsoft has confirmed this to be a problem in SNA Server version 2.11
Service Pack 1 (SP1).
A supported fix is now available, but has not been fully regression-tested
and should be applied only to systems experiencing this specific problem.
The fix is already included in SNA 3.0. Unless you are severely impacted by
this specific problem, Microsoft recommends that you wait for the next
Service Pack that contains this fix. Contact Microsoft Technical Support
for more information.
| Modification Type: | Major | Last Reviewed: | 6/13/2001 |
|---|
| Keywords: | kbnetwork KB162618 |
|---|
|