SYMPTOMS
When you run the Welcome program, the Calibration tool screen states:
Carefully press and briefly hold stylus on the center of the target.
Repeat as the target moves around the screen. Press the ESC key to
cancel.
If you press ESC to cancel the Calibration tool, the Welcome program
returns you to the previous screen, where only the Press ENTER To Continue
option is available. When you press ENTER, the Welcome program returns
you to the Calibration tool screen.
If you complete the calibration process and then press
ENTER, you receive
the following message:
New calibration setting have been measured. Press the ENTER key to
accept the new settings. Press the ESC key to keep the old settings.
If you press ESC, the Welcome program returns you to the previous screen,
where only the Press ENTER To Continue option is available. When you
press ENTER, the Welcome program returns you to the Calibration tool
screen.