Netflex-3: No Adapter Found When Installing SFM (157818)
The information in this article applies to:
- Microsoft Windows NT Workstation 3.51
- Microsoft Windows NT Server 3.51
This article was previously published under Q157818 SUMMARY
If you install Services for Macintosh (SFM) on a Compaq system with a
Netflex-3 adapter in Windows NT 3.51, the installation may fail with the
following error:
Setup cannot find any network adapter for Services for Macintosh. You
will be unable to use Services for Macintosh. Try adding a network
adapter or enable the bindings for the AppleTalk protocol.
If Services For Macintosh is currently installed and you attempt to
configure SFM from the Control Panel tool, the following error message
appears:
The AppleTalk protocol registry parameters cannot be read.
One or more parameters might be missing or contain invalid entries.
If you currently have Compaq Support Software Diskette (SSD) 1.18
installed, you may get the following error after you install SFM and
restart the computer:
Event ID 13
No adapter is configured to be the default adapter.
CAUSE
Netflex-3 drivers installed through the Compaq SSD 1.18 do not properly set
up the registry values that SFM needs for successful installation.
RESOLUTION
To work around this problem, perform one of the following:
- Update to SSD 1.19 or later. This suggestion is recommended.
- Modify the registry as described below:
WARNING: Using Registry Editor incorrectly can cause serious problems
that may require you to reinstall your operating system. Microsoft
cannot guarantee that problems resulting from the incorrect use of
Registry Editor can be solved. Use Registry Editor at your own risk.
Remove Services for Macintosh and then make the following changes:- Start Registry Editor (Regedt32.exe) and find the following registry
location:
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet
\Services\Cpqnf3x\Paramete
where x represents the number of your adapter. It is important not to
add the value to the Cpqnf3 key. - From the Edit menu, click Add Value and add the following values to
the Parameters subkey in all instances of Cpqnf3x and then click OK.
Value name: MediaType.
Data type: RegDword.
- In the Dword editor add the value: 1 Hex.
NOTE: Any of the following values may apply:
1 - Ethernet
2 - Token Ring
3 - ARCNet
4 - FDDI
5 - Apple LocalTalk - Quit Registry Editor.
Reinstall Services for Macintosh and reapply any Windows NT service packs
that were previously installed. You may then reinstall the latest SSD,
before restarting your computer.
| Modification Type: | Major | Last Reviewed: | 11/5/2003 |
|---|
| Keywords: | kbnetwork KB157818 |
|---|
|