Joining a Domain During Automated Setup Fails (153743)


The information in this article applies to:

  • Microsoft Windows NT Workstation 3.5
  • Microsoft Windows NT Workstation 3.51
  • Microsoft Windows NT Server 3.5
  • Microsoft Windows NT Server 3.51
  • MSPRESS Microsoft Windows NT Resource Kit 3.5
  • MSPRESS Microsoft Windows NT Resource Kit 3.51
This article was previously published under Q153743

SUMMARY

Joining a domain during an automated Windows NT Setup may fail in some instances.

CAUSE

There are various causes for failures. The most common ones are listed below:
  1. Problems communicating with a Primary Domain Controller (PDC) during Windows NT Setup.
  2. Not creating a new computer account for the system attempting to join the domain.
  3. Specifying a Workgroup name as well as a domain name in the answer file.

MORE INFORMATION

You must be able to contact a PDC during Setup if you want to join a domain. If the PDC is across a router, you will need to use a routable protocol such as TCP/IP. This may also involve configuring a DHCP Server to supply a valid WINS Server address or using an LMHOSTS file with #PRE #DOM statements to assist in resolving Netbios names. For more information on TCP/IP name resolution, refer to the "Name Resolution for Windows Networking" section in the TCP/IP manual included with Windows NT Server.

From Cps.hlp included in the Windows NT Resource Kit: 

   If you specify a domain to join, there must be a computer account on the
   server for the domain, and the account must never have been joined to.


Another common problem involves the Ntlanman.inf file that is used in setting up the network, including joining a domain. The issue is that Ntlanman.inf first attempts to set the Workgroup name by comparing STF_AUTOWORKGROUP to "" (the empty string). If this is successful the domain information is ignored. To avoid this issue, modify the [DefaultValues] section of your answer file (that is, Unattend.txt, Profile.ini, Defaults.inf) as follows: 

   DefaultWorkgroup = ""


Do not attempt to comment the line by placing a semicolon in front of DefaultWorkgroup.

For more information on automating Windows NT Setup, refer to Volume 1, Chapter 3 of the Windows NT Resource Kit 3.51.
Modification Type:MajorLast Reviewed:12/16/2003
Keywords:KB153743
©2003 Microsoft Corporation. All rights reserved.