Backup Domain Controllers May Fail to Join the Domain (153081)

The information in this article applies to:

Microsoft Windows NT Server 3.5
Microsoft Windows NT Server 3.51

This article was previously published under Q153081

SYMPTOMS

Windows NT backup domain controllers (BDCs) may have difficulty joining a domain if the Hewlett-Packard (HP) 10/100 PCI LAN card is being used. The following error message appears:

Could not find the domain controller for this domain.

CAUSE

The HP driver for the 10/100 PCI LAN card is defective.

RESOLUTION

HP has a new driver for this card. Install the latest driver from the ftp site for HP. This is located at:

   FTP.HP.COM/pub/networking/software/J2585b.exe.

   www.hp.com/cposupport/networking/software/j2585b.exe.html.

When this file uncompresses, you need to replace the current driver with Hpddnd3.SYS.

NOTE: You must use the -d switch when decompressing this file.

STATUS

The third-party products discussed here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.

The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Microsoft in no way guarantees the accuracy of this third-party contact information.

Modification Type:	Major	Last Reviewed:	10/29/2003
Keywords:	kbnetwork KB153081