ErrMsg: Error Writing to LPT1: System Cannot Find File Specified (150498)


The information in this article applies to:

  • Microsoft Windows 2000 Server
  • Microsoft Windows 2000 Advanced Server
  • Microsoft Windows 2000 Professional
  • Microsoft Windows 2000 Datacenter Server
  • Microsoft Windows NT Server 3.1
  • Microsoft Windows NT Server 3.5
  • Microsoft Windows NT Server 3.51
  • Microsoft Windows NT Server 4.0
  • Microsoft Windows NT Workstation 3.1
  • Microsoft Windows NT Workstation 3.5
  • Microsoft Windows NT Workstation 3.51
  • Microsoft Windows NT Workstation 4.0
  • Microsoft Windows NT Advanced Server
This article was previously published under Q150498

SUMMARY

When you try to print to a local printer attached to the parallel port, the following stop error message is reported by WIN32 Spooler:
Error Writing to LPT1: for document <application name>
<path \ file name>: the system cannot find the file specified.

-or-

There was an error found when printing the document "document name" to LPT1:. Do you want to retry or cancel the job?
For example, you try to print the file Probrep.txt from Notepad, and following stop error message is displayed:
Error Writing to LPT1: for document notepad
C:\winnt35\system32\probrep.txt: the system cannot find the file specified.

-or-

There was an error found when printing the document "probrep.txt" to LPT1: Do you want to retry or cancel the job?
This error is generated any time the Parallel.sys driver is not started. This can happen if NTDETECT does not find a valid parallel port on your system, or if the parallel device is disabled or stopped with the Devices tool in Control Panel. In Windows 2000, check Device Manager to see if LPT1 is set to disabled.

Furthermore, if the parallel device driver is not started, and you attempt to start it manually, error 20 (hardware not detected) appears.

RESOLUTION

Jumper the motherboard to use the standard parallel port or check the port setting in CMOS to ensure that the operating system can detect the parallel port for printing.

MORE INFORMATION

Some newer motherboards have the capability to support enhanced parallel port (EPP), Enhanced Communication Port (ECP), and standard parallel port settings. This is usually a jumper on the motherboard rather than a system BIOS option.

Windows NT versions 4.0 and earlier do not support EPP or ECP bi-directional communication ports and will cause the parallel port detection to fail if set to use either one of these standards.

For additional information, click the article number below to view the article in the Microsoft Knowledge Base:

125307 EPP and ECP Bi-Directional Port Support

Modification Type:MajorLast Reviewed:6/3/2003
Keywords:KB150498
©2002 Microsoft Corporation. All rights reserved.