How to Set a Fax Modem to Answer Calls Automatically (147133)


The information in this article applies to:

  • Microsoft Windows 95
This article was previously published under Q147133

SUMMARY

This article describes how to configure Microsoft Fax so that your modem automatically answers the phone to receive incoming faxes.

NOTE: This article assumes that the Microsoft Fax information service is installed in your Microsoft Exchange profile.

MORE INFORMATION

To configure a modem to automatically answer incoming calls, use the following steps:
  1. Click Start, point to Settings, click Control Panel, and then double-click Mail And Fax.
  2. Click Microsoft Fax, and then click Properties.
  3. On the Modem tab, click the modem you want to use, and then click Properties.
  4. In the Answer section, click Answer After X Rings. If you want to change the number of rings before the modem answers the phone from the default value of 3, select any number from 2 to 10.
  5. Click OK or Close until you return to Control Panel.
Modification Type:MajorLast Reviewed:12/17/2000
Keywords:kbinfo KB147133
©2002 Microsoft Corporation. All rights reserved.