ADT2: WX1200 OLE Controls Cause Error Without OLE 2.02 or Later (146883)
The information in this article applies to:
- Microsoft Access Developer's Toolkit 2.0
- Microsoft Access 2.0
This article was previously published under Q146883 SYMPTOMS
When you attempt to use the OLE controls included in the Microsoft Access
Developer's Toolkit OLE (Custom) Controls Service Pack, you may receive an
error message unless you have OLE version 2.02 or later installed on your
computer. When you use these OLE controls in Windows NT 3.51 or Windows 95
using the OLE version 2.01 DLLs included with Microsoft Access 2.0, you may
also receive an error message. When you run code that references these OLE
controls, Microsoft Access may prompt you to input a value or may generate
a generic error message.
CAUSE
The DLLs required to support the new OLE controls must be OLE 2.02 or
later. For more information about this topic, please see the following
article in the Microsoft Knowledge Base:
ARTICLE-ID: 123593
TITLE: ACC2: OLE 2.02 Required to Use Custom Controls
RESOLUTION
Install OLE version 2.02 or later. OLE 2.02 is available with the Microsoft
Access version 2.0 Service Pack. For information about how to obtain the
Service Pack, please see the following article in the Microsoft Knowledge
Base:
ARTICLE-ID: 122927
TITLE : WX1124: Microsoft Access Version 2.0 Service Pack
| Modification Type: | Major | Last Reviewed: | 10/22/2003 |
|---|
| Keywords: | kberrmsg kbinterop kbprb KB146883 |
|---|
|